Residential Docks

Modules are connected by brackets where they join at the corners.  The leg post goes down though a sleeve in the bracket and is secured in place with a set screw.  Put the pipe through the bracket sleeves with the footpads on the bottom before you go into the water, so they can just be dropped down when in place.

Start with the module closest to shore, and work out from there by attaching modules one by one.  You can float out the sections via inner tube or something similar.  When you’ve got it all set up, the post covers snap on over the pipe or post caps go on the top. Reverse process for removal as necessary.

See complete instructions here. We are also available for installation help via phone including evenings and weekends.

The general process is as follows.  Insert float plugs (don’t over tighten) and install floats.  Install splines.  Install module fastener kits (K/U bolts), and brackets, both hand tight.  If there is a gangway or module with hinge kit, that can be staged and assembled separately. See floating dock instructions here.

For pilings, attach auger feet and secure with bolts.  Insert auger foot through the piling bracket and lower, remaining vertical. Screw into bottom with pipe wrench, as indicated in instructions.

For removal, just take out pilings or anchoring and float sections to tie off at shore.